I have a Zigmo2 PR35-19 wifi configuration board into which I have plugged an ncd.io PR55-22 communication module.
When I used NCD BaseStation to set it up, the wifi details don’t load: it hangs with the progress bar stopped at about 10% of the progress.
The red LCD “PWR” light is on on the configuration board, and the comms module has a flashing red light on it - one short flash followed by an even shorter one.
I have succeeded in getting the PR55-22 into “configuration mode” (blue LED flashing), but I still don’t get any communcation with it via BaseStation.
Can anyone help with the modes PR55-22 can go into? There is an R and a C button, and I got it into configuration mode, but can’t get it out of that now.