SW and board revs

Software
1

I am looking to replace an industrial relay controller 16 channel SPDT 8 channel ADC board with the USB interface built into the board (Rev A?), with a Rev B model utilizing the ZUSB interface. My question is if the drivers that are available for DL support both boards, or were they different? I have little documentation on the existing system, so I am unsure what was used.

Thanks

2

Hi Jared,

Yes, the existing drivers/software used for the previous controller will work with the new controller. Software/Computer should not detect any difference between the two devices.

Thank you,
Travis Elliott

3

Thanks Travis! that’s what I was hoping

1 Like