Pycom Adapter - No MicroPython REPL visible over USB to UART


I’m trying to set up the USB to UART on this Pycom adapter ( for the NCD hardware but I cannot seem to get it to reach the micropython REPL over serial USB.

I have the LoPy set up in standard UART operation mode, do I need to check what pins the UART is connected to in order to view the REPL via serial USB over the Pycom Adapter?



Hi Alex,
The usb to uart converter is connected to tx0 and rx0 of the wipy2/lopy.
I will recommend checking with pycom community and see if there is something special needs to be considered on the software side.
I use wipy with ssh.