NCD environmental sensor did not enter configuration mode

Products
1

Hi,

I followed the below document to setup the environmental sensor.
https://ncd.io/ncd-io-wireless-sensor-raw-commands/

When we enter configuration mode, the expected response from the sensor is similar to this: 7E 00 1C 90 00 13 A2 00 41 91 1B 83 FF FE C2 7A 00 00 00 23 00 00 50 47 4D 00 00 00 00 00 00 0A

Frame type is 90.

But I get a response 7E 00 1E 10 00 00 00 00 00 00 00 FF FF FF FE 00 00 7A 00 00 00 1B 00 00 50 47 4D 00 00 00 00 00 00 7B with completely different frame type. What should I do to successfully enter configuration mode? Is there any timeouts in config mode, so that it automatically returns to run mode?

2

its correct frame.

In order to go back into run mode. you will need to change the PAN id back to 7FFF.

Thanks