Bidirectional Pressure Sensor - data send frequency

Hardware
1

I am new to NCD sensors and Node-Red.

I just received my Enterprise IIoT Gateway and 2 Bidirectional pressure sensors. I was able to get the sensors to show data in node red debug.

How do I increase the frequency with which the sensor sends its data? For my testing, I’d like it to send every 10 seconds.

I searched the sensor and gateway blogs but could not find instructions on how to do this.

2

you can sue set the delay value to 10 sec using node red.

3

I watched the video and did not see an explanation on how to increase the data frequency…

4

I found it here: PR55-5A sensor parameters setup - #2 by TravisE_NCD_Technica

1 Like
5

Hi @dmwengineering You could use this video as a guide. It is the same procedure with your Enterprise Gateway and Pressure sensor, be sure to select the correct type.

image
image444×594 28 KB

In video set 30 seconds, but you can use 10 seconds.

Thank you,
Eduardo M.